Skip to the main content
PeabodyMake a free story

🔧 Workshop, level 10

What the trails say and what they ask. Print it for the class, or put the same questions on the board with a live quiz.

Workshop, level 10

🌉 Bridges and Trusses

Why do so many bridges look like rows of triangles?

  • Why do so many bridges look like rows of triangles? Engineers call a frame like that a truss, and it works because a triangle is rigid: if you join three bars at their ends with pins, the shape cannot change unless one of the bars actually gets longer or shorter. A frame of four bars, such as a rectangle, can fold over sideways into a slanted shape even when none of its bars bend at all. In a well-designed truss, the bars meet at joints, and the weight of the traffic is passed along to those joints, and as a result, each bar is mainly pulled along its length, which is tension, or pushed along its length, which is compression, and it is hardly bent. That arrangement allows builders to use slender bars that weigh far less than a solid beam of the same strength would.
  • A simple truss stretched across a gap behaves a lot like a beam. Its upper bars, called the upper chord, are squeezed in compression, while its lower bars, the lower chord, are stretched in tension, and the slanted bars in between carry either one force or the other. Engineers pay close attention to which bars are being pushed, because a long, thin bar under compression can buckle, which means it suddenly bows out to the side, while a bar under tension simply stays straight. The Pratt truss, patented in 1844, makes clever use of this idea. Its slanted bars are placed so that they are in tension, and its upright bars are in compression, which keeps the pushed bars short. According to the National Park Service, the Pratt truss became the most common bridge type of the late 1800s and early 1900s.
  • Other kinds of bridges send their forces along different paths. An arch carries its load mainly in compression, but a curved arch also pushes outward at both of its ends, a sideways force called thrust, so the supports at the ends of an arch, which are called abutments, must be heavy and firmly set in the ground to keep the arch from spreading apart and sliding. A suspension bridge works in the opposite way. Its road hangs from cables that drape over tall towers, and the cables are in tension. The towers carry the load down to the ground in compression, while each end of the main cables is tied into a huge anchorage, often set in solid rock or a massive block of concrete, which holds against the pull. Where an arch pushes outward on its supports, the cables of a suspension bridge pull inward on theirs.

Try it at home: Build a square and a triangle from straws and pins or tape together, then press on each corner and see which one holds its shape.

Questions and answers

Bridges and Trusses

  1. 🔺 Why is a triangle rigid? Its shape can't change unless a bar changes length (Three bars joined at their ends can only make one shape.)
  2. In a well-designed truss, how is each bar mainly loaded? Pulled or pushed along its length (Loads pass to the joints, so each bar is mainly in tension or compression.)
  3. Which bars of a simple truss are squeezed in compression? The upper chord (A simple truss acts like a beam, with its upper bars squeezed.)
  4. What does it mean for a bar to buckle? It suddenly bows out to the side (A long, thin bar that is pushed too hard can bow out sideways.)
  5. 📏 Which bar is in the most danger of buckling? A long, thin bar in compression (Bars in tension stay straight; long, thin bars that are pushed can buckle.)
  6. In a Pratt truss, which bars are in tension? The slanted bars (The Pratt truss puts its slanted bars in tension and its upright bars in compression.)